3.76
8. Tighten main head bolts finger tight, then install the
two 6 mm outer bolts.
CYLINDER HEAD TORQUE PROCEDURE
• Torque six main head bolts in sequence shown in the
image below to specification.
TORQUE
Cylinder Head Bolts:
Torque in sequence
Step 1: 8 ft-lbs (11 Nm)
Step 2: 43 ft-lb (59 Nm)
Step 3: Tighten add’n 90° (¼ turn)
• Install two M6 outer head bolts
e
and torque to
specification.
TORQUE
M6 Outer Head Bolts:
7 ft-lb (10 Nm)
CAMSHAFT / CARRIER ASSEMBLY
1. Lubricate all camshaft lobes and bearing journal
surfaces with black moly grease or Premium Starter
Grease (PN 2871460).
2. Place the camshaft in the cylinder head.
3. Lubricate rocker arms, rollers and shafts with engine
oil. Lay out in proper location as marked upon
disassembly.
4. Assemble camshaft carrier with rocker arms and
shafts. Slots
q
must face outward of carrier to allow
bolt installation and to properly orient the oiler holes
in shafts.
CAMSHAFT / CAMSHAFT CARRIER
INSTALLATION
1. Loosen all valve adjuster lock nuts.
2. Turn adjuster screws out (counterclockwise) until
they lightly seat against rocker arm.
NOTE
DO NOT force screws against rocker arm. The adjuster
pivot ball may be damaged if forced.
3. Using a 12mm Allen socket, rotate the flywheel
clockwise (direction of engine rotation) until Top
Dead Center mark
w
on flywheel is aligned with
crankcase parting line
e
. This is TDC for MAG side
cylinder.
ENGINE / COOLING SYSTEM
To Next Page
Loading...
