4
4.37
5. Using a T20 driver, remove the screw
q
retaining
the ignition coil to the airbox.
6. Remove the coil assembly and disconnect the high
tension leads by pulling on the coil side end caps.
7. Install the spark plug wires.
NOTE
Be sure to install the PTO (long) wire
e
on the coil
terminal nearest the airbox.
8. Install the coil assembly and securely tighten the
mounting screw.
9. Upon assembly, make sure the spark plug wires are
retained by the airbox.
10. Reinstall shift linkage, upper right-hand side panel
and seat.
FUEL SYSTEM
To Next Page
Loading...
