7
7.65
12. Remove the through-bolt fastener retaining the right
rear upper A-arm to the bearing carrier. Pivot the
wheel hub and bearing carrier down to remove the
drive shaft from the gearcase.
NOTE
Take care not to stretch the brake line while removing
the drive shaft.
13. Remove the drive shaft from the rear gearcase by
pulling sharply.
14. Remove the (4) through-bolts retaining the rear
gearcase to the frame.
15. Move the gearcase forward in the frame and remove
the vent line from the gearcase.
16. Using care, remove the rear gearcase through the
bottom of the frame.
NOTE
Be sure to move the rear brake line out of the way upon
removal to prevent from damaging it.
FINAL DRIVE
To Next Page
Loading...
