8
8.19
21. Install new lower A-arm assembly onto vehicle
frame. Torque new bolts to specification.
TORQUE
A-Arm Assembly Bolts:
37 ft. lbs (50 Nm)
22. Insert lower A-arm ball joint end into bearing carrier.
Install new pinch bolt and fastener hardware. Torque
new pinch bolt to specification.
TORQUE
New Pinch Bolt Fastener:
17 ft. lbs (24 Nm) Plus 90 Degrees
23. Grease all (4) A-arm grease fittings after reassembly.
CAUTION
Upon A-arm installation completion, test vehicle at low
speeds before putting into service.
STEERING / SUSPENSION
To Next Page
Loading...
