8
8.25
5. Route brake line on top of lower A-arm and install
retainer (if applicable).
6. Reinstall lower portion of shock and lower portion of
stabilizer linkage to the lower A-arm. Torque shock
mounting fastener (see Figure 10-19) to
specification. Torque linkage fastener to
specification.
TORQUE
Shock Mounting Fastener:
37 ft-lbs (50 Nm)
Linkage Fastener:
37 ft-lbs (50 Nm))
7. Install the wheel and torque wheel hub retaining nuts
to specification.
TORQUE
Wheel Hub Retaining Nuts:
80 ft. lbs. (108 Nm)
CAUTION
Upon A-arm installation completion, test vehicle at low
speeds before putting into service.
STEERING / SUSPENSION
To Next Page
Loading...
