11.16
RIDER INFORMATION DISPLAY - SPORTSMAN / SCRAMBLER
The rider information display is located in the instrument cluster. All segments will light up for 1 second at start-up.
NOTE
If the instrument cluster fails to illuminate, a battery over-voltage may have occurred and the instrument cluster may
have shut off to protect the electronic speedometer.
q
Vehicle Speed Display - Analog display of vehicle speed in MPH or km/h
w
Information Display Area - Odometer / Trip Meter / Tachometer / Engine Temp. / Engine Hours / Service
/ Clock - LCD display
e
MPH / KM/H Display - MPH is displayed when the instrument cluster is in the Standard mode. KM/H is
displayed when the cluster is in the Metric mode.
r
High Beam Indicator - LED icon illuminates when the headlamp switch is in the high beam position.
t
Fuel Level Indicator - LCD bar graph indicating current fuel level. All segments will flash when the last
segment is cleared indicating a low fuel warning.
y
Clock - Display current time in either 12–hour or 24–hour formats
u
Engine Temperature Indicator - LED icon illuminates when the ECM determines the engine is
overheating. The indicator will flash to indicate the engine is overheating. The indicator will stay lit and not
flash if a severe overheating condition exists.
i
Service Interval Indicator - Preset at the factory and adjustable by the user; a flashing wrench symbol
alerts the operator that the preset service interval has been reached and maintenance should be
performed. The wrench icon will flash for 10 seconds upon start-up once it reaches 0.
o
Check Engine MIL - Illuminated when the ECM has detected a diagnostic trouble code in the engine
management system.
a
AWD Indicator - Illuminated when the AWD / TURF switch is in the AWD position.
s
TURF Indicator (INTL. Only) - Illuminated when the AWD / TURF switch is in the TURF position.
d
Neutral Gear Indicator - LED icon illuminates when the gear shifter is in the neutral (N) position.
f
Gear Position Indicator - Displays gear shifter position.
H = High
L = Low
N = Neutral
R = Reverse
P = Park
– = Gear Signal Error (shifter stuck between gears)
g
Power Steering System MIL (EPS Models) - LED icon illuminates when a fault has occurred in the EPS
system. This indicator also turns on momentarily when the key is turned on.
h
Turn Signal / Hazard Lamp Indicator - If equipped with turn signals, the LED icon illuminates whenever
the left, right or hazard blinker is activated.
j
Active Descent Control Indicator - Illuminated when the RH control switch is in the ADC 4x4 position
and ADC is active.
ELECTRICAL