2
2.15
2. Remove the rubber strap retaining the airbox cover
and open the cover.
NOTE
High lifter Models: Use a T27 torx bit to remove the air
box cover screw and remove the cover.
3. Remove the air filter assembly from the airbox.
Cleaning:
4. Slip the pre-filter screen
w
off of the main filter
element
q
. Clean the pre-filter with hot soapy water.
5. Rinse and dry thoroughly.
6. Inspect pre-filter screen for tears or damage.
7. Inspect main filter and replace if necessary. If the
filter has been soaked with fuel or oil it must be
replaced.
Installation:
8. Inspect airbox cover seal for damage. It should
adhere tightly to the cover and seal all the way
around. Replace seal as needed.
9. Reinstall pre-filter screen over main filter. Be sure the
screen covers entire surface of main filter without
folds, creases, or gaps.
NOTE
Apply a small amount of general purpose grease to the
sealing edges of the filter before reinstalling.
10. Install air filter assembly into the airbox and position
it correctly before closing the airbox cover.
NOTE
Proper placement of the air filter is important to prevent
air leaks.
11. Close airbox cover and secure cover by installing the
rubber strap.
NOTE
High Lifter Models: Reinstall and tighten the cover
screw until the cover is sealed.
MAINTENANCE
To Next Page
Loading...
