11
11.59
LIGHTS
HEADLAMPS
HEADLIGHT ADJUSTMENT, POD
1. Place the vehicle on a level surface with the headlight
approximately 25 ft. (7.6 m) from a wall.
NOTE
Rider weight must be included on the seat while
performing this procedure.
2. Place the transmission in PARK.
3. Measure the distance from the floor to the center of
the headlight and make a mark on the wall at the
same height.
4. Start the engine and turn the headlight switch to high
beam.
5. Observe the headlight aim on the wall. The most
intense part of the headlight beam should be aimed 2
in. (5 cm) below the mark placed on the wall in Step
3.
6. Loosen the adjustment screw at the rear of the
headlamp.
7. Adjust the beam to desired position and tighten the
screw.
WARNING
Due to the nature of ATVs and where they are
operated, headlight lenses become dirty. Frequent
washing is necessary to maintain lighting quality. Riding
with poor lighting can result in severe injury or death.
HEADLIGHT REPLACEMENT, POD
1. Remove the screws retaining the front half of the pod
assembly.
2. Remove the front half of the pod.
3. Disconnect the lamp
q
from the main harness.
4. Remove the lamp form the housing.
NOTE
If lens housing replacement is required, do so at this
time.
5. Install new lamp.
6. Connect lamp to main wiring harness.
ELECTRICAL
To Next Page
Loading...
