128
MAINTENANCE
Choke Adjustment Procedu re 4-cycle Engines
Toggle Switch
1. Push choke knob to the full
off position.
2. Slide boot off in-line cable
adjuster sleeve. Loosen
adjustment locknut on in-
line cable adjuster.
3. Turn cable sleeve adjusting
nut clockwise on in-line ad-
juster until 1/8″ (.3 cm) or
more choke toggle free
play is evident.
4. Turn the cable sleeve adjusting nut counterclockwise on the in-
line cable adjuster until the toggle has zero free play. Then ro-
tate it clockwise until 1/8″ to 1/4″ (.3 to .6 cm) toggle free play
is evident.
5. Tighten adjustment locknut.
6. Slide boots back over cable adjuster sleeve until they touch at
the middle point of the sleeve.
To Next Page
Loading...
Need help?
General
