12
EN
2.5.4 Surface control
• Check that the cleaner lter is clean so as not to a ect the cleaner's behaviour.
• Once the cleaning cycle has been launched, monitor the cleaner's behaviour when climbing the walls and when it
brushes the waterline.
• You can use the (Surface Control System) bu on at any me depending on the cleaner's behaviour: refer to the
table below.
• The new con gura on will be e ec ve the next me the cleaner climbs the walls.
• 2 LEDs are lit by default
The new con gura on will be e ec ve the next me the cleaner climbs the walls.
.
Cleaner behaviour to be observed Ac on
The cleaner quickly climbs the walls and goes past the
waterline, aspirating air: Reduce the number of LEDs.
Press:
The cleaner slowly climbs the walls and stops below the
waterline: Increase the number of LEDs.
Tip: Op mise wall cleaning and water line brushing opera ons
According to the type of pool lining, the cleaner will behave differently when climbing the walls. The cleaner
has the
According to the type of pool lining, the cleaner will behave differently when climbing the walls. The cleaner
function to optimise wall cleaning, then waterline brushing on all types of lining.
However the func on is set, the suc on power remains at its maximum at all mes when the cleaner
is moving across the oor of the pool.
To Next Page
Loading...
Need help?
General
