2
7. Unscrew the adjustable plug to completely
expose the holes before turning on the
WaterStars. After the initial option, the
adjustable plug can be adjusted (see Section III).
Please Note: Once the WaterStars is in the
pool, the pods should fill with enough water to
float evenly on the surface of the pool.
8. Pull the fountain to the desired location in
the pool. If the fountain will not reach the desired
area, you may want to add an additional ten foot
hose section available through a participating
Polaris dealer (part #7-310-00).
If the fountain will not remain in the desired area,
or if it will not anchor properly, you may want to
shorten the hose as described below.
D. Cutting the Hose
Please remember that once the hose has been
cut, it may be too short for the fountain to be
moved to a new location at a later time.
1. After choosing the desired location for the
fountain, measure the amount of hose that you
wish to remove and disconnect the WaterStars
from the pool wall.
2. Collapse the hose inside the quick
disconnect with your fingers and pull off the
quick disconnect.
3. Cut off the desired amount of hose.
4. Recollapse the hose and slide it back into
the quick disconnect. Be sure only one hose
corrugation is inside the lip of the quick
disconnect.
5. Remove the adjustable plug and slide your
finger through the open ing to pop the hose back
to its original shape. Replace the adjustable plug
and reconnect the WaterStars to the pool wall.
III. Adjustments
A. Fountain Height Adjustment
An adjustable plug is installed in the quick
disconnect to allow the height of the fountain to
be manually adjusted. Loosening the adjustable
plug will decrease the height of the fountain,
while tightening the plug will increase it.
If you have a Polaris 380, 280, or 180 and have
too much water pressure, you will need to install
the restrictor washer included with the fountain.
Snap the restrictor washer into the quick
disconnect. If you still have too much water
pressure, call our Customer Service Department
at 1-800-VAC-SWEEP.
B. Glory Display Presentation
Tightening or loosening the spreader in
combination with tightening or loosening the
adjustable plug will vary the display of the glory
fountain head. Experiment with different
combinations of the two adjustments until you
are satisfied with the water display.
To Next Page
Loading...
Need help?
General