Polaroid 539957-020 Rev. A - Message 122: Magnetic Stripe Format Problem; Message 123: Insert New Card then Continue; Message 124: Insert same Card then Continue

57
Hints & Tips
• When the printer recognizes that a supported ribbon is installed, all enhanced
product features are enabled and successful card printing can begin.
Message 122: Magnetic stripe format problem
The magstripe data sent does not match the format set in
the printer.
1. Ask your Manager for information about the data to
send.
Hints & Tips
The printer has format settings for the data that can be encoded on the card. The
magstripe data sent does not match those settings.
• Ask the Manager to verify that the card, the data, and the printer settings
match.
• See Magnetic Stripe for information about data allowed for specific formats.
• Make sure fonts or escapes are used correctly.
Message 123: Insert new card then continue
The card requires you to insert a new card in
the exception slot.
1. Insert the card in the printer.
2. Resume.
Hints & Tips
• Make sure to use the correct type of new card for this job.
• Do not touch the card surface to be printed:
• Handle cards by their edges
• Wear gloves
Message 124: Insert same card then continue
The card must be turned by hand to print the second side.
1. Turn the card over.
2. Insert the card in the printer.
3. Resume.