Polaroid onestep 2

User Manual 14
User Manual15
How to use
the OneStep
Charge the camera
Important The OneStep 2
will not be fully charged upon
purchase — it should be fully
chargedbeforerstuse.To
charge the camera, plug the
USB charging cable into the Mi-
cro-USB slot on the camera’s
back panel, and the other end
of the cable into a charger,
such as a smartphone adapter
or your computer’s USB slot.
TheredashchargeLED will
turn off when the battery is
fully charged.
A full charge usually takes
about 2 hours through a wall
socket with a smartphone
adapter, or up to 4 hours
through a computer’s USB
slot. A fully-charged OneStep 2
camera will have enough pow-
er to shoot 15-20 packs of
lm,dependingonusage.
Remember to turn your camera
off after every use to conserve
battery life.
Box contents
01 OneStep 2 Camera
02 USB Charging Cable
03 User Manual
04 Camera Neck Strap
1. Turn the
camera on/off
To turn the camera on,
slide the power switch into the
ONposition(down).Theash
charging LED on the back panel
will start blinking to charge
theash,andtheremaining
lmcounteronthetopofthe
camera will light up to indicate
that the camera is switched on.
To turn the camera off again,
return the power switch to the
OFF position.
2. Load the lm
Slidethelmdoorlatch
toopenthelmdoor.Push
thelmcassettealltheway
in,withthelm’sdarkslide
facing up.
Note Please check indi-
viduallmpackagingfor
development time, handling
and storage details.
3. Close lm door
Whenyouclosethelmdoor,
the darkslide will eject from
the camera automatically,
underneaththelmshield.
Theplasticlmshieldis
designed to protect images
from light as they develop — it
should not be removed. Take
the darkslide out from under
thelmshieldandletthe
lmshieldrollbackup.Ifthe
darkslide has not ejected,
removethelmpackand
re-insert it, making sure it is
pushed all the way to the back
of the camera.
4. Set the Flash
& Lighten/Darken
Flash Thecameraashwill
trigger by default when you
shoot with the OneStep 2. To
shootwithouttheash,press
andholdtheashoverridebut-
ton on the back panel as you
press the shutter button.
Warning Shooting without
ashwillreducecamera
performance and picture
qualityinmostlightingsit-
uations except brightly-lit,
sunny environments. We
recommend always shoot-
ingwithash.
Lighten/Darken Use the light-
en/darken switch on the right
side of the lens barrel to adjust