User Manual 14
User Manual15
How to use
the OneStep
Charge the camera
Important The OneStep 2
will not be fully charged upon
purchase — it should be fully
charged before rst use. To
charge the camera, plug the
USB charging cable into the Mi-
cro-USB slot on the camera’s
back panel, and the other end
of the cable into a charger,
such as a smartphone adapter
or your computer’s USB slot.
The red ash charge LED will
turn off when the battery is
fully charged.
A full charge usually takes
about 2 hours through a wall
socket with a smartphone
adapter, or up to 4 hours
through a computer’s USB
slot. A fully-charged OneStep 2
camera will have enough pow-
er to shoot 15-20 packs of
lm, depending on usage.
Remember to turn your camera
off after every use to conserve
battery life.
Box contents
01 OneStep 2 Camera
02 USB Charging Cable
03 User Manual
04 Camera Neck Strap
1. Turn the
camera on/off
To turn the camera on,
slide the power switch into the
ON position (down). The ash
charging LED on the back panel
will start blinking to charge
the ash, and the remaining
lm counter on the top of the
camera will light up to indicate
that the camera is switched on.
To turn the camera off again,
return the power switch to the
OFF position.
2. Load the lm
Slide the lm door latch
to open the lm door. Push
the lm cassette all the way
in, with the lm’s darkslide
facing up.
Note Please check indi-
vidual lm packaging for
development time, handling
and storage details.
3. Close lm door
When you close the lm door,
the darkslide will eject from
the camera automatically,
underneath the lm shield.
The plastic lm shield is
designed to protect images
from light as they develop — it
should not be removed. Take
the darkslide out from under
the lm shield and let the
lm shield roll back up. If the
darkslide has not ejected,
remove the lm pack and
re-insert it, making sure it is
pushed all the way to the back
of the camera.
4. Set the Flash
& Lighten/Darken
Flash The camera ash will
trigger by default when you
shoot with the OneStep 2. To
shoot without the ash, press
and hold the ash override but-
ton on the back panel as you
press the shutter button.
Warning Shooting without
ash will reduce camera
performance and picture
quality in most lighting sit-
uations except brightly-lit,
sunny environments. We
recommend always shoot-
ing with ash.
Lighten/Darken Use the light-
en/darken switch on the right
side of the lens barrel to adjust
To Next Page
Loading...
Need help?
General
