Page 7
Loading print ribbon
1 Open the printer cover.
2 Remove the ribbon cartridge.
3 Remove both used ribbon spools from the
cartridge (if present).
Tips: Handling print ribbon
• Keep unused ribbon in the original package.
• Don’t place ribbon on a dusty or dirty surface–
dirt could damage the printhead.
4 Run a cleaning card and replace the cleaning
sleeve at the same time that you load a new print
ribbon. See ”Cleaning the printer” on page 17 for
the steps to follow.
— Load the new roll of print ribbon on the
cartridge. Put the full spool of ribbon on the
supply spindle of the ribbon cartridge. Push
until the spool clicks onto the spindle.
— Put the empty take-up spool on the spindle
with the solid black gear. Push until the spool
clicks onto the spindle.
1
1
To Next Page
Loading...
