Polaroid PDC 3000 - If Your Powermac or Powerpc Has Other SCSI Devices

Setting up 35
IMPORTANT: ALWAYS CONNECT THE CAMERA TO
AC POWER WHEN IT IS CONNECTED TO THE
COMPUTER. IF THE CAMERA OR ANY OTHER SCSI
DEVICE TURNS OFF WHILE CONNECTED, IT COULD
CORRUPT DATA ON YOUR HARD DISK.
Because the PDC-3000 camera is internally terminated, you
must install it as the last device in your SCSI chain as follows:
1 Turn off the computer, all SCSI devices, and the camera.
2 Remove the terminator (a) from the last SCSI device in your
SCSI chain.
10B.CDR
Note: Keep the terminator. You must reconnect it if you use
the computer while the camera is not attached.
If your PowerMac or
PowerPC has other
SCSI devices