Setting up 36
3 Attach the DB25/50 pin Centronics adapter (b) to the end of
the SCSI cable (c).
Use only the SCSI cable provided with the camera. Other
cables may appear similar, but could damage the camera or
your computer. If you are using an Apple PowerBook
computer, read the special instructions on page 36 before
continuing.
4 Connect the DB25/50 pin Centronics adapter (b) to the
connector from which you removed the terminator.
5 Connect the other end of the SCSI cable (d) to the SCSI
connector on the PDC-3000 camera.
6 Connect the camera to AC power with the power
adapter/trickle charger (e).
IMPORTANT: ALWAYS CONNECT THE CAMERA TO
AC POWER WHEN IT IS CONNECTED TO THE
COMPUTER. IF THE CAMERA OR ANY OTHER SCSI
DEVICE TURNS OFF WHILE CONNECTED, IT COULD
CORRUPT DATA ON YOUR HARD DISK.
In addition to the cables and adapters described in the
previous sections, Apple PowerBook computers require a 1-
meter SCSI cable and an HDI-30/DB25 adapter (available
Connecting to an
Apple PowerBook
To Next Page
Loading...
