Polaroid PDC 3000 - Setting to Stand-Alone Mode

Using the PDC-3000 camera 75
If your PDC-3000 camera is connected to a computer, you
must release it from computer control to operate in the stand-
alone mode.
Use either of these two methods to release it:
· Use the computer to release the camera. (See Releasing the
camera from computer control, page 157 for
PowerMac/PowerPC or page 201 for PC.)
· Disconnect the camera from the computer. (See
Disconnecting the camera from your computer on page 53.)
WARNING: DO NOT DISCONNECT OR CONNECT
ANY DEVICE WHILE THE DEVICE OR YOUR
COMPUTER IS TURNED ON. DOING SO COULD
DAMAGE THE DEVICE, YOUR COMPUTER, OR BOTH.
Setting to stand-alone
mode