Polaroid ProCam - Removal; Replacement; Exposure and Ranging PC Boards

3 - 19
2. Replacement
a. Replace the Rear Lens Baffle (Figure 3-14), then slide the Shutter
Assembly straight down into the Bellows/Cone Assembly. Be sure that
the locking catches at left and right ends engage the Shutter Baseblock.
b. Replace the Cone Cap over the Rear Lens Baffle and secure it with its
flat head screw.
Exposure and Ranging PC Boards
1. Removal
a. Remove the four rubber Retainer rings from the molded studs on the
Bellows/Cone Assembly, which secure the Exposure PC Board
(Figure 3-15).
b. Disconnect the Ranging Board (J10) and two Interface Connectors (J9
and J8) from the Exposure Board and remove the Exposure Board
(Figure 3-15).
Figure 3-15. Removing Retainers and Connectors from Exposure Board
J 9
J 8
EXPOSURE BOARD
(F ROM INTERFACE B OAR D)
J 10
(FROM RANGIN G BOARD)
RETAINER RINGS