Polaroid Spectra/Image One Board - Removing LCD Board from Ranging Board; Removing LCD Board

18
Removing LCD Board from Ranging Board
1. Hold the camera vertically, with the front down.
2. Using Square Socket Tool Bit with Handle, P/N 11913, carefully remove the two
machine screws (A in Figure 2-9) securing the LCD board to the ranging board.
Hold the bracket (D in Figure 2-9) temporarily in place with your finger.
Warning: Do not use Torque Limiting Screwdriver, P/N CR 13397, to
remove the screws.
3. Carefully lift off the LCD board. Be careful not to lose the following parts, which are
released when the LCD board is removed:
• Clear plastic spacer block (C in Figure 2-9)
• Gold-colored elastomeric zebra connector (B in Figure 2-9)
• Metal retainer (D in Figure 2-9)
Figure 2-9. Removing LCD board
Ranging Board
LCD Board
Warning: Remove only with Square
Socket Toll Bitwith Handle (P/N 11913).
Do not use Torque Limiting Screwdriver.
D
A
C
B