52
PROGRAMMING REMOTE CONTROL
Direct Device Code Setup
Although your Remote Control is set up to provide control
of this TV, you can specify other devices to be controlled,
according to the following steps:
Mode → <<SET>> (2 blinks) → 5- digit device codes (2 blinks)
STEP 1 Locate the desired device in the Device code list in the following pages.
STEP 2 Select the mode by pressing DVD, CAB/SAT, or AUX.
STEP 3 Depress and hold <<SET UP>> button for a minimum of 3 seconds. When successful,
this TV will blink twice after pressing <<SET UP>>.
STEP 4 Enter the 4-digit code for the desired device. This TV will blink once on each digit
entry, excluding the last digit. It will blink twice to confi rm whether the valid code is
programmed.
Mode Device Assignment
Device
Group no.
TV Locked to this TV (Default) -------
VCR Universal VCR, DVD, PVR 2
CBL Universal Cable, Satellite, Video Accessory 0
AUX
Universal Tuner, Amplifi er, CD, Mini Disc. And Misc. Audio,
Home Automation
3
Example: [VCR]→<<SET>> (2blinks)→[2]→[0]→[0]→[3]→ [5] (2 blinks).
NOTE 1 : Each digit must be entered within 10 seconds, or the Remote Control shall exit programming state
NOTE 2 : Two short LED blinks indicate recognition of the code, after which device control via the remote is
enabled.
NOTE 3 : A long LED display indicates non-recognition of the code, at which time the code should be re-
entered.
To Next Page
Loading...
