Installing the battery
1. Insert the battery into the battery mount paying
attention not to damage the rubber gasket.
2. First insert the upper part of the battery and
then the bottom part of the electric connectors.
3. Press the battery until a click is heard to lock it.
Battery may be assembled even if the key is not
inserted.
4. Proceed carefully and without too much strength
to avoid damaging the electric connectors.
AVVERTENZE: Before riding your bicycle, make sure that the battery is locked in place
and charging port cap is closed.
When transporting the bicycle, remove the battery and place it in a dry place, at the
same time covering the electrical contacts against atmospheric agents.
DANGER – ATTENTION: Do not ride the bicycle with the key inserted, to
prevent the battery from falling out and avoid loosing the key.
To Next Page
Loading...
