6.0- Servicing – Errors list
Servicing
Lubricate the e-bike gear every 5000 km for maximum noise reduction.
- remove the crown-holder if necessary
- unscrew the cap of the grease tank and add about 2/3 grams of Polini grease.
(item 955.435.001)
- Fit all the parts again paying attention to tight the crown holder screw properly
(5/6Nm torque)
Display does not read the speed.
Verify the distance between speed sensor and magneto (maximum 15mm) in the position
indicated by the line. If it is not enough or too much or if the speed sensor hasn’t been
properly connected the E-bike motor works in the emergency mode.
In this case, loosen the screw of the magneto and fix the magneto on the ray so that it is
at a correct distance respect to the speed sensor symbol. If even after this operation the
speed has not been displayed, contact an authorized bicycles’ dealer.
To Next Page
Loading...
