Safety Precautions
FCC
Statement
1
. This device complies
with Part 15 of the FCC
Rules.
Operation
is
subject to the following
two
conditions:
(1)
This device may not cause
harmful
interference.
(2)
This device must accept any
interference received, including
interference that may cause
undesired operation.
2.
Any Changes or modifications not expressly
approved by the party responsible for
compliance
could
void the user's authority
to operate the equipment.
NOTE:
This equipment has been tested and found
to
comply
with the
limits for a
Class
B
digital device,
pursuant to Part 15 of the
FCC Rules.
These
limits
are designed to provide reasonable protection against
harmful
interference
in
a residential
installation.
This
equipment generates uses and can radiate radio
frequency energy and,
if
not
installed
and used
in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is
no guarantee that interference will
not occur
in
a
particular installation. If
this equipment does cause
harmful
interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user
is
encouraged to try to correct the
interference by one or more of the
following measures:
- Reorient or
relocate
the receiving antenna.
-
!Increase
the separation between the equipment
and receiver.
-Connect the equipment into
an
outlet
on a
circuit different from that to which
the receiver
is
connected.
-
Consult
the
dealer
or
an
experienced radio!TV
technician for
help.
FCC
RF Radiation Exposure Statement
1
. This transmitter must not be colocated
or operating
in
conjunction with any other
antenna or transmitter.
2.
This equipment
complies with
FCC
radiation
exposure
limits
set forth for
an
uncontrolled
environment. This equipment
should
be
installed
and operated with minimum distance 20cm
between the radiator
&
your body.
FCC RF Warning
This equipment must be
installed
and operated
in
accordance with provided instructions and the
antenna(s) used for this transmitter must be
installed
to provide a separation distance of at least 20
em
from
all
persons and must not be co-located
or
operating
in
conjunction with any other antenna
or
transmitter.
End-users and
installers must be provide with antenna
installation
instructions and transmitter operating
conditions for satisfying
RF
exposure compliance.
IC
RF Radiation Exposure Stament
This device
complies
with the Canada
portable
RF
exposure
limit set forth for
an
uncontrolled
environment and
are
safe for intended operation as
described
in
this
manual.
The further
RF
exposure
reduction can be achieved if the product can be kept
as
far as
possible
from the user body or set the device
to
lower
output power
if
such function
is
available.
Canada, Industry
Canada
(IC)
Notices
This
Class
B digital
apparatus
complies
with Canadian
ICES-003.
To
reduce potential radio interference to
other users, the antenna type andits gain
should
be so
chosen that the equivalent
isotropically
radiated power
(e.i.r.p.)
is
not more than that permitted for successful
communication.
To Next Page
Loading...