Bluetooth Call
On a Bluetooth enabled device:
1. Select RealPresence Trio in the Bluetooth setting.
2. Dial or place a call to a contact on the device.
3. Select the RealPresence Trio as the audio source when prompted.
Locked / Logged Out Call
Trio systems can be setup to allow calls to specific Authorized calls when the device is locked.
1. Tap New Call.
2. Select a number from the Authorized Call list display.
3. Tap to dial.
Note: Any listed Authorized Call Numbers provided are pre-defined by the administrator.
Place Intercom Calls
Check with the system administrator to find out whether this feature is available on the system.
The intercom allows users to place a call to a contact that is answered automatically on the contact’s
phone if the contact is not on an active call. If the contact’s line is active, the contact can choose to answer
the intercom call immediately, or the intercom call will be answered automatically after the active call ends.
Use the Intercom
1. Tap Intercom.
2. Enter a number or select a Contact.
3. Tap to Dial.
4. Speak after the tone.
5. Wait for a reply, or tap Hangup if no reply is needed.
Note: The system administrator can set up the system to automatically call a specific contact
number when the Intercom soft key is pressed. If the system is set up this way, press the
Intercom soft key and wait for the call to be answered before speaking.
Use Intercom During a Call
While in an active call:
1. Press Hold for the call.
2. Tap Intercom.
3. Enter a number or select a Contact.
4. Tap to dial.
5. Speak after the tone or when the call is answered.
6. Tap Hangup when finished.
7. Select the On Hold call and tap Resume
To Next Page
Loading...
