Decline Incoming Calls
Select Decline in the incoming call window. The call will go directly to voicemail if that is setup.
End Audio Calls
Active calls may be ended on the system at any time, however calls on hold must be resumed first.
To end active calls, do one of the following:
Current Call: Tap Hang Up
Viewing Multiple Calls: Select the call and tap Hang Up
On Hold Call: Select the call, tap Resume , then tap Hang Up
Use Do Not Disturb
When Do Not Disturb (DND) is enabled, the following occurs:
The DND icon is displayed in the status bar.
When the system is idle, the DND icon is displayed next to the line on the Home screen. If the New
Message Notifications or Forwarding features are enabled, a related icon is displayed instead.
Enabling DND on shared lines disables ringing only. A visual notification of the call still displays offering the
option to answer or silence the call.
Enable Do Not Disturb
Do Not Disturb (DND) may be enabled to prevent the system from ringing and to send all incoming
calls directly to voicemail. All calls received while DND is enabled are logged in the Recent Calls list.
To enable or disable Do Not Disturb:
Navigate to Settings > Features > Do Not Disturb, and tap Enable/Disable.
Enable Do Not Disturb for One Line
Do Not Disturb can be enabled for a particular line rather than all lines.
1. Navigate to Settings > Features > Do Not Disturb > Line Select
2. Select the desired line.
3. Then tap Enable for Do Not Disturb.
Enable Do Not Disturb on Multiple Lines
By default, the Do Not Disturb feature applies to all lines on the system. Your system administrator can
set up the system so that you can enable the feature on a per-line basis. To automatically enable Do
Not Disturb for all lines:
1. Navigate to Settings > Features > Do Not Disturb.
2. Select Set All to enable DND for all lines.
Disable Do Not Disturb
Do Not Disturb can be disabled when you are ready to resume receiving calls again.
To disable Do Not Disturb:
Navigate to Settings > Features > Do Not Disturb and tap Disable.