OFF 00s < x < XXs Nothing
ON 00s < x < 60s Search for source base/repeater
ON 60s < x < XXs Search for any base/repeater in the system
Button
In the below table the action of the button press is presented.
Button Press Action
1 00s < x < 02s Nothing
1 02s < x < 06s Delete registration
Old registration is deleted, and a new registration procedure is
started.
1 18s < x < 60s Enable or disable repeater monitor beep tone in handset during call.
1 60s < x < XXs Nothing
LED
LED Indication Action
GREEN Off Power Off
GREEN Slow flash Unlocked, Searching for base station
GREEN Double flash
Registration/subscription mode and searching for open base station –
registering procedure.
GREEN Steady on Locked to base station and ready for use - idle
RED Off No handset relayed by repeater
RED n flash n handset relayed by repeater
RED Steady on 1. Registration procedure timed out after 5 min.
2: When key is held pressed the LED will light up in 2 sec. to indicate
that releasing the key will delete registration, LED turns off after 4
more sec.
RED/GREEN
Flashing
Red/Green
Recovery mode – repeater is locked to base station/repeater without
repeater mode activated.
1: Sync. Source base station/Repeater not found (Manual mode).
2: Timeout during RPN allocation due to busy base station/Repeater.
To Next Page
Loading...