Repeater registration options:
There are 2 different ways to register Poly repeater’s “Local Automatic” and “Manually”
Local Automatic:
In this mode the repeater registers to the base station with best signal strength, this option is only recommended for
single cell systems and Multi cell systems where the repeater is only able to sync with one specific base station.
Manually:
Manual registration is used in most cases when adding repeaters to a multi cell system. Manual registration allows to
determine what base stations the repeater must connect to.
Register repeater(s) “Local Automatic”:
NOTE: Do not power on the repeaters before they have been added on the base station
NOTE: When adding first repeater the base station(s) will reboot, this is because encryption is being enabled, the
same goes if all repeaters is deleted, then the system will reboot to disable encryption.
Step 1: To register repeater(s), navigate to the Repeater page.
Screen shot
Step 2: Click” Add Repeater” and select “Local Automatic” from the dropdown
To Next Page
Loading...