Poly Voyager Focus 2 Office - The Basics; Power on;off; Adjust volume; Make, answer, end calls

Siri
Google Assistant
:02
1x
1x
2x 3x
/
Support
Timer
Custom Button
olume
Play / Pause
Power
Device Controls
Headphones
Headset
Support
Timer
Custom Button
Volume
Play / Pause
Power
Device Controls
Support
T
Custom Button
Volume
Play / Pause
Power
Device Controls
Lock
Indicator Light
Music
ANC
Devices
Phone
Mobile
Computer
Camera
Charging/Battery
Scaled to 45% of full size
Devices
Charging/Battery
Blutooth
Device Status
Support
Settings
Daisy Chain / Link
Lock
ANC
Timer
Custom Button
Power
Device Controls
Headphones
Mobile
Computer
Camera
Headset
Support
Settings
Daisy Chain / Link
Lock
ANC
Timer
Custom Button
Power
Device Controls
Custom Button
Volume
Mic / Mic Mute
Play / Pause
Power
Device Controls
Headset
olume
Mic / Mic Mute
Play / Pause
Power
Volume
Mic / Mic Mute
Play / Pause
Power
Device Controls
ANC:
Low/High
Slide the switch to power on or off.
• Headset volume Fine-tune your headset volume by adjusting the headset's volume up (+)
and down (-) controls.
• Desk phone volume When you are on a desk phone call and your voice is too quiet/loud,
adjust the speaking
volume on the bottom of the base. If your caller's voice is too loud/
quiet on a desk phone call, adjust the listening volume.
• Base ringtone volume Adjust the base ringtone volume setting in Poly Lens Desktop App.
This ringtone alerts you if you are not wearing your headset and a call comes in.
Adjust headset microphone volume (softphone)
Place a test softphone call and adjust softphone volume and PC sound volume accordingly.
On the front of the base there are 2 Audio
buttons: computer and desk phone. These
buttons allow you to switch to a different phone line/audio channel.
Make a call (computer or desk phone)
1 Tap an Audio button on your base display. You hear a dial tone.
Desk phone only: Press the phone's Headset button or manually remove the handset if you
don't have an HL10 lifter or EHS cable.
TIP If you do not hear a dial tone, turn over the base and adjust the switch (A--G). “A” works for
the majority of desk phones. "D" works for Cisco phones.
2 Dial from your softphone or desk phone.
Answer or end a call
To answer or end a call, choose:
• Tap the headset Call button.
• Computer or desk phone: Tap the corresponding Audio button
Desk phone only: If you don't have an HL10 lifter or EHS cable, Press the phone's Headset
button or manually remove the handset when answering a call or hang up the handset when
ending a call.
Mute
Mute your headset on an active call:
The Basics
Power on/off
Adjust volume
Make, answer, end
calls
11