GP44 Semi-Automatic Strapping Machine
OPERATION -5-
POLYCHEM CORP.
MODEL NO.
SERIAL NO.
INTRODUCTION
This manual supplies all the necessary information for the correct use of the machines supplied by Polychem
Corporation.
Instructions, drawings, tables and any other information contained in this manual are all confidential. They
may not be reproduced, either fully or partially, without the authorization of Polychem Corporation. Polychem
reserves all exclusive rights on this matter, and is enabled to carry out all changes that will be required.
This manual should be kept in good condition and in an easily accessible place, along with the spare parts
manual, so that they may be quickly referenced when necessary.
The machine serial number should always be included when a request for information is made. This helps
insure that the correct replacement parts are specified for the machine.
Polychem Corporation
SERIAL NUMBER LOCATION
There are two identifying markers on the machine. The bottom frame is stamped on the cross brace where
the machines frame is bolted to the caster frame. The machine will be stamped as shown below:
COR-0067
A Polychem tag is also affixed to the machine. It appears as shown below.
To Next Page
Loading...