28
No Response from Feature Key Presses
Verify phone is in active state:
• Make a call to the phone to check
for inbound call display and ring-
ing as normal. If successful, try to
press feature keys within the call to
access Directory or Buddy Status for
example.
• Press
followed by System
Status and Server Status to confirm
line is actively registered to the
server.
• Reboot the phone to attempt re-reg
-
istration to the server.
Display shows “Network Link is Down”
Verify LAN cable is properly connected:
• Check termination at the switch or
hub (furthest end of the cable from
the phone).
• Check that the switch or hub is opera
-
tional (flashing link/status lights) or
contact your System Administrator.
• Press
followed by System
Status and Network Status. Scroll
down to verify LAN port is Active.
• Reboot the phone to attempt recon
-
nection to the network.
No Ringing
Verify incoming ring setting and volume
levels:
• Adjust the ringing level from the front
panel using the volume up/down keys.
• Check that ring type selection is not
Silent Ring.
Verify successful outbound or inbound
calling:
• As “No Display” above.
• Check same status of handset,
headset (if connected) and through
the hands-free speakerphone.
No Audio on Headset
Verify correct connections:
• Ensure the headset is plugged into
the jack marked
Headset at the rear
of the phone.
• Ensure the headset amplifier (if pres
-
ent) is turned on and/or the volume
is correctly adjusted.
• Ensure that headset is compatible
with the phone.
Safety and Compliance
Part 15 Rules
This device complies with Part 15 of the
FCC Rules. Operation is subject to the fol-
lowing two conditions:
1. This device may not cause harmful
interference, and
To Next Page
Loading...
