Appendix - Polycom Open Collaboration Network (POCN)
Polycom, Inc. 387
The following procedures are a summary of the configuration procedures.
The detailed procedures begin with Procedure 1: Set the MIN_TIP_COMPATIBILITY_LINE_RATE System
Flag.
Configuring the Collaboration Server
1 Set the MIN_TIP_COMPATIBILITY_LINE_RATE System Flag
2 Configuring the Collaboration Server to statically route outbound SIP calls to DMA or CUCM
3 Configuring the Collaboration Server’s H.323 Network Service to register with DMA/Resource
Manager gatekeeper
4 Configuring a TIP enabled Profile on the Collaboration Server
5 Configuring an Ad Hoc Entry Queue on the Collaboration Server if DMA is not used
6 Configuring a Meeting Room on the Collaboration Server
7 Configuring Participant Properties for dial out calls
Configuring DMA
If DMA is present in the configuration perform procedures Configuring DMA to route SIP calls to CUCM and
Configuring a Virtual Meeting Room (VMR), otherwise skip to procedure Configuring Resource Manager to
route H.323 calls to Collaboration Server.
1 Configuring DMA to route SIP calls to CUCM
2 Configuring a Virtual Meeting Room (VMR)
The procedures for configuring DMA are described in detail in Polycom Unified Communications
Deployment Guide for Cisco Environments.
Configuring the Resource Manager
1 Configuring Resource Manager to route H.323 calls to Collaboration Server
HDX Systems:
• 7000 HD Rev C
• 8000 HD Rev B
• 9006
• 4500
V3.0.3
Requires TIP option key.
Peripheral Polycom Touch Control 1.3.0
SIP ONLY (no TIP support) Version(s)
Spectralink wireless phones 8020/8030
Polycom VVX 1500 V4.0
Polycom VVX 1500 C V3.3.1
KIRK Wireless Server 300/600v3/6000
Supported Polycom products
To Next Page
Loading...
