Administration and Utilities
Polycom®, Inc. 722
10 Define the following parameters:
SNMPv3 - Traps
Field Description
SNMP Trap Version Specifies the version, either Version 1 2 or 3 of the traps being sent to the IP
Host. Polycom software supports the standard SNMP version 1 and 2 traps,
which are taken from RFC 1215, convention for defining traps for use with
SNMP.
Note: The SNMP Trap Version parameters must be defined identically in the
external SNMP application.
Trap Destination This box lists the currently defined IP addresses of the Manager terminals to
which the message (trap) is sent.
IP Enter the IP address of the SNMP trap
recipient.
All Versions
Community Name Enter the Community Name of the
manager terminal used to monitor the
MCU activity
Version 1
and Version
2
User Name Enter the name of the user who is to have
access to the trap.
Version 3
Authentication
Protocol
Enter the authentication protocol: MD5 or
SHA.
Privacy Protocol Enter the privacy protocol: DES or AES.
Engine ID Enter an Engine ID to be used for both
the Agent and the Trap.
Default: Empty
To Next Page
Loading...
