System Configuration Flags
Polycom®, Inc. 762
BLOCK_CONTENT_LEGACY_FOR
_LYNC
This flag is used to control the system behavior in an environment
where some Lync clients use the Polycom CCS plug-in and some
do not.
When set to NO (default), Content is sent to all Lync clients over
the video channel, including those with the plug-in installed, even
when the Send Content to Legacy Endpoints is disabled. Other,
non-Lync legacy endpoints will not be affected by this flag and will
receive content according to the Send Content to Legacy
Endpoints settings in the conference Profile.
When set to YES, Content is not sent to Lync clients over the video
channel including those with the Polycom CCS plug-in installed,
even when the Send Content to Legacy Endpoints is enabled.
Other, non-Lync legacy endpoints will not be affected by this flag
and will receive content according to the Send Content to Legacy
Endpoints settings in the conference Profile.
BONDING_CHANNEL_DELAY When connecting a bonding group, this is the delay (number of
1/100 seconds) between dialing attempts to connect sequential
channels.
The channel per second connection performance of ISDN
switches can vary and can cause timing issues that result in
bonding channel disconnection.
Default: 50
BONDING_DIALING_METHOD When set to:
• SEQUENTIAL
The MCU initiates channel connections sequentially until it
reaches the number of channels defined by the
BONDING_NUM_CHANNELS_IN_GROUP flag.
When a channel is connected, dialing begins for the next
channel in the group.
• BY_TIMERS
The MCU initiates channel connections sequentially using the
values of the BONDING_CHANNEL _DELAY and
BONDING_GROUP_DELAY flags.
The first group of channels is dialed, using the
BONDING_CHANNEL_DELAY between dialing attempts for
each channel in the group.
The Collaboration Server then implements the
BONDING_GROUP_DELAY, before dialing the first channel of
the next group.
Default: SEQUENTIAL
BONDING_GROUP_DELAY
(ISDN)
When connecting several bonding groups, this is the delay
(number of 1/100 seconds) preceding the first dialing attempt to
connect the next bonding group.
Default: 500
The MCMS System Flags
Flag Description Add?
To Next Page
Loading...
