System Configuration Flags
Polycom®, Inc. 792
REMOVE_H323_HIGH_PROFILE_
CAP_TO_NON_POLYCOM_VENDO
R
Used to disable High Profile protocol. Use of Polycom’s proprietary
protocol, High Profile, may result in interoperability issues when
used with other vendors’ endpoints.
Possible values: YES / NO
Default: NO
REMOVE_H323_HIGH_QUALITY_
AUDIO_CAP_TO_NON_POLYCOM
_VENDOR
Used to disable the following Audio Codecs:
• G231
• G7221C
• G7221
• G719
• Siren22
• Siren14
Possible values: YES / NO
Default: NO
REMOVE_H323_LPR_CAP_TO_N
ON_POLYCOM_VENDOR
Used to disable H.323 LPR protocol. Use of Polycom’s proprietary
protocol, H.323 LPR, may result in interoperability issues when
used with other vendors’ endpoints.
Possible values: YES / NO
Default: NO
REMOVE_IP_IF_NUMBER_EXISTS Between the time a conference is scheduled and when it becomes
active, the IP of an endpoint may change, especially in an
environment that uses DHCP. This flag determines if the E.164
number is to be substituted for the IP address in the dial string.
Range: YES / NO
Default: YES - The IP address will be substituted with the E.164
number.
RESTRICT_CONTENT_BROADCA
ST_TO_LECTURER
If set to YES, only the conference lecturer may send content to the
conference.
If set to NO, any conference participant can send content.
Default: YES
RFC2833_DTMF Controls the receipt of in-band and out-of-band DTMF Codes.
When set to:
• YES The RMX will receive DTMF Codes sent in-band.
• NO The RMX receive DTMF Codes sent out-of-band.
The RMX always sends DTMF Codes in-band (as part of the
Audio Media stream).
Range: YES/NO
Default YES
RMX_MANAGEMENT_SECURITY_
PROTOCOL
Enter the protocol to be used for secure communications.
Default: TLSV1_SSLV3 (both).
Default for U.S. Federal licenses: TLSV1.
The MCMS System Flags
Flag Description Add?
To Next Page
Loading...
