Tempo – this knob has different functions. First, it is used to set the global tempo for
your project, with a value between 10 and 400 BPM.
When used per track, the Tempo knob allows you to set a selected track’s speed
(playback) relative to the project’s tempo (also on the external MIDI clock). You
can set divisions and multiples of the tempo rate ranging from 1/16 up to 8/1. The
slowest division is Pause.
When a certain track playback is paused, you can manually trigger its steps
containing notes while holding the encoder clicked down.
Swing – each track can have its own swing value. Select all tracks to apply a global
swing value.
Available for both the internal sample-based engine and MIDI sequencing.
Playhead behavior/movement visually resembles the applied swing.
Track Length – allows you to set the track length from 1 to 64 steps. Its values are
displayed both on the screen and on the grid.
Press and hold the Shift key. The function pads will indicate available track step
pages, with up to four pages indicated, depending on the selected number of
steps. Switch between them to edit the track steps in intervals between the 16, 32,
48, and 64 steps.
You can perform the Quick Copy action on the track pages, and it is possible to
copy and paste between different tracks.
When the track is longer than 16, 32, 48, and up to 64 steps, the function pads will
indicate track pages with green pads. The currently edited page is lit.
Play Mode – gives you access to 35 classic and custom play modes which determine
the order in which track steps are played. This provides an option to shuffle and remix
your existing patterns. Custom play modes determine the order in which track steps are
played.
These play modes are available for both internal sample-based and MIDI
sequencing.
Volume – gives you control over the sample volume. Where 0 dB means the original
volume of the sample.
Pan – allows you to set the stereo panorama. With the settings of > 100L – Center –
100R.
To Next Page
Loading...
