Care and Cleaning
Step 1.
Remove all ornaments and decorations.
Step 2.
Unplug the cord from the wall and then unplug each
section of the tree.
Step 3.
Gently lift the tree top straight up to remove from the
center section and fold all branches towards the pole.
Step 4.
Repeat this step for the bottom tree section.
Step 5.
Carefully place all tree sections into a shipping box and
tape it shut.
Step 6.
Store your tree in a cool, dry place away from sunlight.
Step 7.
Keep out of reach of pets and children.
Children must be supervised to ensure that the items are not
used as toys.
CAUTION and in essence the following: To reduce risk of fire and
electric shock:
CAUTION and in essence the following: To reduce risk of fire and
electric shock: Disconnect the decorative item from the power
source before performing any maintenance or cleaning.
Do not install nor place near gas equipment or electric heaters,
chimneys, candles or other similar heat sources.
Disconnect the product when leaving the house, going to sleep
or if left unattended.
Do not hang ornaments or other objects to the cord, cable or
lighting chain.
Do not cover the decorative item with cloth, paper or any other
material that is not part of the product when in use.
Do not install the chain in a manner that may cut or damage the
wire insulation.
For indoor use only.
Operation
Turning on the tree
NOTE:
If some bulbs do not light or flicker, search for any loose
plugs and/or broken, loose, or missing bulbs. Replace bulbs
promptly with the replacement bulbs provided in order to
maintain the performance and life expectancy of your tree.
Step 1.
Connect the light strings of the tree together and plug the
power cord into a wall outlet.
Step 2.
If the tree comes with a foot pedal, step on the On/Off
button.
Maintenance
Spare parts
Repairing Loose Hinges
This tree package includes hinge pins, washers, bulbs, and fuses for
any replacement or repair that you need to perform on your tree. If
extra parts are needed, contact the Customer Service Team at 01
800 004 6633
Step 1. Place the branch into the slot of the bracket.
Step 2. Insert a new hinge pin through the holes of the bracket and
secure with a washer.
Wesley Tree
Model: TG76M5412C03; 131194
Troubleshooting
Problem Solution
The tree does
not light
Ensure that all tree sections are plugged
into each other and that the tree is
plugged into the wall. If your tree came
with a foot pedal, step on the On/Off
button.
Check for blown fuses at the light string
and power cord plugs. Replace as needed
with the replacement fuses provided.
Check for loose, broken, or missing bulbs
and replace as needed with the
replacement bulbs provided
a) Grasp plug and remove from the receptacle or other outlet
device. Do not unplug by pulling on cord.
b) Open fuse cover. Slide open fuse access cover on top of
attachment plug towards blades.
c) Remove fuse carefully.
d) Risk of fire. Power cord replace fuse only with 3 Amp,125 volt.
e) Close fuse cover. Slide closed the fuse access cover on top of
attachment plug.
f) Risk of fire. Do not replace attachment plug. Contains a safety
device (fuse) that should not be removed. Discard product if the
attachment plug is damaged.
g) Unplug the item before replacing the fuse.
User servicing instructions
Fuse replacement
SPARE FUSE
To Previous Page
Loading...
Need help?
General
