PEN & BOARD MECHANICS
TIPS FOR USING THE ENO STYLUS
Use only lithium batteries with the pen/stylus. To save battery life, be sure to cap
your pen
when not using it.
It takes about 6-7 seconds for the pen to ‘wake up’ after uncapping or after a few
minutes
with no use. You will have to recap / uncap to wake it up again.
The on/off switch is activated by the cap. It can also be activated if you bump it
with your
fingers while writing / holding the pen. Try to hold the pen further back
to avoid turning it
off during instruction.
Label your pen / stylus. Your computer is paired with one stylus in particular
although you
can pair up to six different utilities (including tablet), it’s easiest to
work with the same stylus
each time.
Do not hold pen at 90 degree angle to board. (The resulting line may ‘skip’)
Keep your pen safe. Replacements cost approximately $200.
TIPS FOR SETTING UP THE PRINT AND SAVE FEATURE
Open the Polyvision Driver
• (right click on the icon located in the bottom right of your screen & choose Configure
Polyvision Driver)
Print
Select the Print tab
From the dropdown menu choose the printer where you would like to print
Choose Printer Properties
• In the Orientation box select Landscape
Save
Click the blue link besides Save in to specify which folder you would like the screen shots to be
saved
Save image size—1600 recommended
Click the drop down next to Save as file type & choose Adobe PDF
Under Base file name choose Use Date/Time in the names
Change Disabled to Enabled next to Save PDF in landscape orientation
Page 4
To Next Page
Loading...
