Reverse
Press “REV” to rapidly rewind the tape.
Press “PROG’ or “REV” again to stop it.
The radio will play during this operation.
To
Play the Next Selection
Press “NEXT” or “SEEK
A’’
to hear the
next selection (instead of waiting until the
current selection is finished.)
For “NEXT” to work properly, your tape
must have at least three seconds of silence
between each selection.
The radio will not play during this
operation.
To
Replay the Current Selection
Press “PREV” or “SEEK
V”
to play a
selection again.
For “PREV” to work properly, your tape
must have at least three seconds of silence
between each selection.
The
radio will not play during this
operation.
Program
Press “PROG’ to switch from one side of
the tape to the other or to stop the tape
from searching.
Noise Reduction
Press
00
to reduce tape noise. This
symbol will appear in the display.
To Stop the Tape Player
Turn the power off
or
turn the ignition
key off. The cassette stays in
the
player and will resume playing at the
point where it stopped.
cassette and switch to the radio. Press
“TAPE-PLAY’’ to restart
the
cassette
at
the
point where it stopped.
e
Press “EJECT” to remove the cassette
or stop the cassette and switch to
radio. “EJECT” will work with the
ignition or radio off. Press “EJECT”
to load a cassette when the radio is
off.
0
Press “AMEM” to stop playing the
NOTE: This radio has a “broken tape”
feature that will eject broken or misfed
tapes. Because of this feature, CD:
changers that plug into
the
tape deck
will
not work in this system.
Theft-Deterrent System
Your audio system is equipped with the
“THEFTLOCK’ theft-deterrent system.
See “Theft-Deterrent System” at the end
of this section.
111
. . .
To Next Page
Loading...
