Changing a
FIat
Tire
If
a tire
goes
flat, avoid further tire and
wheel damage by driving s’lowly to a level
place. Turn on your hazard warning
flashers.
The following steps will tell you how to
use the jack and change a tire.
The equipment you’ll need is
in
the rear
area.
First you must remove the clcse-out
panel. See “Close-Out Panel” in the
Index.
On
convertible models,
you
must also
remove the trunk access panel. It’s at the
upper back of the trunk. Turn the two
screw knobs under the trunk
edge
a
quarter
turn
counterclockwise
to
remove
lhe
panel.
Find the plastic screw heads in
the
trim
?anel over the spare tire. Use a coin or a
tey to turn the screw heads until the slots
mint front and back. Lift the
trim
panel
md move it out
of
the way.
I
171
...
To Next Page
Loading...
