EasyManua.ls Logo

Pontiac 1994 Firebird - Page 223

Pontiac 1994 Firebird
290 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Service and Appearance Care
Don’t use any of these unless this manual
says you can. In many uses, these will
damage your vehicle:
0
Alcohol
Laundry Soap
0
Bleach
0
Reducing Agents
Cleaning the Inside
of
Your
Pontiac
Use a vacuum cleaner often to get rid of
dust and loose dirt. Wipe vinyl or leather
with a clean, damp cloth.
Your Pontiac dealer has two
GM
cleaners,
a solvent-type spot lifter and a foam-type
powdered cleaner. They will clean normal
spots and stains very well. Do not use
them on vinyl or leather.
Here are some cleaning tips:
Always read the instructions
on
the
Clean up stains as soon as you can
-
Use a clean cloth or sponge, and
cleaner label.
before they set.
change to a clean area often. A soft
brush may be used
if
stains are
stubborn.
D
Use solvent-type cleaners in a
well-ventilated area only. If you use
them, don’t saturate
the
stained area.
clean the entire area immediately or it
will set.
If a ring forms after spot cleaning,
Using Foam-Type Cleaner on Fabric
Vacuum and brush
the
area to remove
any loose dirt.
Always clean a whole trim panel or
section. Mask surrounding trim along
stitch or welt lines.
Mix Multi-Purpose Powdered Cleaner
following the directions on the
container label.
Use suds only and apply with a clean
sponge.
Don’t saturate the material.
Don’t rub it roughly.
As soon as you’ve cleaned the section,
use a sponge to remove the suds.
Rinse the section with a clean, wet
sponge.
Wipe off what’s left with a slightly
damp paper towel or cloth.
Then dry it immediately with a blow
dryer or a heat lamp.
NOTICE:
Be careful with a hair dryer or heat
lamp.
You
could scorch the fabric.
0
Wipe with a clean cloth.
Using Solvent-Type Cleaner
on
Fabric
First, see if you have to use solvent-type
cleaner at all. Some spots and stains will
clean
off
better with just water and mild
soap.
If you need to use a solvent:
Gently scrape excess soil from the
trim material with a clean, dull knife
or scraper. Use very little cleaner, light
pressure and clean cloths (preferably
cheesecloth). Cleaning should start at
the outside of the stain, “feathering”
toward the center. Keep changing to
a
clean section of the cloth.
. .
.222

Related product manuals