yellowblue
2-65
3. Open the latch and close the T-top. Check to see if
there are any gaps showing. Unlatch the T
-top and
adjust the sunshade as required.
4. Once the sunshade is installed properly, you can
stick the Velcro
R
buttons on the glass for a proper fit
every time you install the sunshades. To do this, first
remove the T-top with the sunshade installed and
place it upside down on a table or bench. Take care
not to scratch the glass.
5. Pull the sunshade back a little and remove the backing
paper from the velcro buttons. Push the sunshade
back into place, sticking the velcro to the glass.
6. Install the T
-top, close the latch and lock the
T
-top. Repeat the above steps for the
passenger
-side sunshade.
To Next Page
Loading...
