10. Put the bulb assembly back into the lamp housing
and turn the bulb socket one-quarter of a turn
counterclockwise.
11. Reinstall the bulb access cover making sure it
is in place.
12. Align the retaining clips on the back of the headlamp
with the rectangular holes in the mounting panel.
13. Push firmly on both ends of the headlamp to snap
it into position.
14. Push the retaining clip down to its original position.
Front Turn Signal, Sidemarker and
Parking Lamps
1. Open the hood. See Hood Release on page 5-11
for more information.
2. Remove the two inboard screws attaching the lamp
to the fender bracket.
3. Unsnap the lamp assembly by lifting straight up.
4. Pull the lamp assembly away from the vehicle.
5-48
To Next Page
Loading...
