2. Insert the slide locks under the two rear floor
retainers by pushing the button down and pressing
them outward.
You may have to apply downward pressure to the
floor track assembly to engage the slide locks under
the floor retainers.
Double check to ensure that the slide locks are
engaged under the retainers and locked into place.
3. Feed the tethered ring upward through the lower
sidewall loop on each side of the vehicle.
Make sure that the tethered ring is placed on the
outer edge of the tailgate, on each side of the
vehicle, for later attachment to the tray.
4. Push and pull on the floor track assembly to make
sure it is locked into place.
Replacing the Sliding Rear
Convenience Tray
The floor track assembly must be installed first for the
sliding rear convenience tray to stay locked into
place. See “Replacing the Floor Track Assembly” listed
previously for more information.
1. Pick up the tray by the handle and support the tray
from the bottom with your other hand.
2. Place the tray onto the floor track assembly.
Make sure that the two front axles are placed over
the hooks on the rear of the floor track assembly.
There are four axles on the bottom of the tray,
two in front and two in back.
Make sure the rollers on the bottom of the tray are
located in the tracks of the floor track assembly.
3. Roll the tray forward into the vehicle until you hear
a click.
4. Press the release lever and pull the tray onto the
tailgate. Connect the hook to the tethered ring
located on each side of the sliding rear convenience
tray.
5. Push the release lever and roll the tray back into
the vehicle.
You will hear a click when the tray is locked into
position.
2-44
To Next Page
Loading...
