SIX CYLINDER ENGINE
6-21
RETAINER,
OIL
FILTER SCREW,
OIL
FILTER SPRING,
OIL
FILTER
BY-PASS
VALVE BY-PASS VALVE RETAINER BY-PASS VALVE
PIN, DISTRIBUTOR
OIL
AND
FUEL
PUMP
GEAR
AND
ECCENTRIC
GEAR
AND
ECCENTRIC
HOUSING
SEAT,
OIL
FILTER
BY-PASS
VALVE
CAP,
OIL
PRESSURE
REGULATOR VALVE
BEARING, DISTRIBUTOR
DRIVE
SEAL,
DISTRIBUTOR
DRIVE SHAFT
SPROCKET
GASKET,
OIL
PRESSURE
REGULATOR VALVE
CAP
SPRING,
OIL
PRESSURE
REGULATOR
VALVE,
OIL
PRESSURE
REGULATOR
BOLT,
OIL
PUMP
COVER
TO
HOUSING
"
Fig.
6-36
Accessory
Drive
Housing—Exploded
View
7. Using new gasket installed over
dowels
(Fig.
6-35) and if necessary, new seal, reverse removal
procedures tightening oil pan and crankcase cover
bolts
to 12 lb. ft.
HOUSING
ASSEMBLY-OIL
PUMP,
DISTRIBUTOR
AND
FUEL
PUMP
(Fig.
6-36J
PRESSURE
REGULATOR VALVE-OIL
PUMP
REMOVE
AND
REPLACE
1. Remove cap washer and spring from housing
assembly.
2
0
Using magnet, remove valve from housing as-
sembly.
3.
Install
valve on spring and install as an as-
sembly.
4.
Install
cap and washer.
OIL
PUMP
REMOVE
AND
REPLACE
1. Remove oil pump cover and gasket.
2.
Remove drive gear and driven gear (Fig. 6-37).
3. Inspect gears for wear and pump cover for ex-
cessive scoring.
Fig.
6-37 Oil
Pump
Gears
To Next Page
Loading...
