TURBO 11YDRA-MATIC TRANSMISSION
7E-59
DETENT
ROLLER
AND
SPRING
ASSEMBLY
mm
Fig.
7E-167 Installing Detent Roller and Spring Assembly
4.
Install
modulator retainer and attaching bolt.
Torque
bolt to 18 lb. ft.
INSTALLATION
OF
GOVERNOR
1.
Install
governor into case (Fig.
7E-169).
2.
Attach governor cover and new gasket with
four (4) attaching bolts. Torque bolts to 18 lb. ft.
INSTALLATION
OF
SPEEDOMETER
DRIVEN
GEAR
1.
Install
speedometer driven gear (Fig.
7E-170).
2.
Install
speedometer driven gear retainer and
attaching bolts.
MODULATOR VALVE
O
-
RING
SEAL
•
/
VACUUM MODULATOR
Fig.
7E-1 69 Installing Governor
INSTALLATION
OF
CONVERTER
ASSEMBLY
With
the transmission in cradle or portable
jack,
install
the converter assembly into the pump assem-
bly,
making certain that the converter hub drive
slots are fully
engaged
with the pump drive gear
tangs and the converter installed fully towards the
rear
of the transmission.
INSTALLATION
OF
TRANSMISSION ASSEMBLY
Reverse
the procedure for transmission removal
as stated on
page
7E-12.
SPEEDOMETER
DRIVEN
GEAR
•0-RGES3G
SEAL
Fig.
7E-168 Installing Vacuum
Modulator
and
Valve
Fig.
7E-170 Installing Speedometer Drive Gear and Sleeve
To Next Page
Loading...
