Pontiac firebird 1968 - Electric Deck Lid Release

ACCESSORIES
15-13
Fig. 15-21 Hood Mounted Tachometer—Firebird
2. Connect precision tachometer to assembly in
car.
3. Remove round metal plug from rear of ta-
chometer housing.
4. Turn engine over at 3500 rpm as indicated
on precision tach (lower or higher readings may-
result in inaccurate needle setting).
5. Insert small screwdriver through hole at rear
of housing and turn rheostat clockwise to lower
needle or counterclockwise to raise needle.
BROWN
TACH
\ TO NEC
LEAD J ON COIL
(-) TERM
ORANGE
CLOCK LEAD (NOT USED)
TACHOMETER
GRAY
GRAY (RHEO. LEAD)
6. When proper needle setting has been obtained
as indicated on precision instrument, turn engine
off, remove precision tachometer and replace unit
by reversing removal procedures.
ELECTRIC DECK LID RELEASE
Refer to Fig. 15-23 for installation of release
switch and dash wiring on both Pontiac and Tempest.
See Fisher Body Manual for trunk unit installation.
ORANGE
(CLOCK POWER)
BROWN
(POWER)
BODY WIRE
(TO RELEASE
SM)
SWITCH
HOLE IN GROVE BOX
TEMPEST
INSTALLATION
SIMILAR
SEE FISHER BODY MANUAL
FOR FURTHER INFORMATION
Fig. 15-22 Instrument Panel Tachometer—Tempest
Fig. 15-23 Electric Deck Lid Release —Pontiac