Rear-facing child restraints should not be installed in the
vehicle, even if the airbag is off.
If the child restraint has the LATCH system, see Lower
Anchors and Tethers for Children (LATCH) on page 2-31
for how to install your child restraint using LATCH. If you
secure a child restraint using a safety belt and it uses a
top tether, see Lower Anchors and Tethers for Children
(LATCH) on page 2-31 for top tether anchor locations.
Do not secure a child seat in a position without a top
tether anchor if a national or local law requires that the
top tether be anchored, or if the instructions that come
with the child restraint say that the top strap must be
anchored.
In Canada, the law requires that forward-facing child
restraints have a top tether, and that the tether be
attached.
You will be using the lap-shoulder belt to secure the
child restraint in this position. Follow the instructions that
came with the child restraint.
1. Move the seat as far back as it will go before
securing the forward-facing child restraint.
When the passenger sensing system has turned
off the right front passenger frontal airbag, the
off indicator should light and stay lit when you
start the vehicle. See Passenger Airbag Status
Indicator on page 4-22.
2. Put the child restraint on the seat.
3. Pick up the latch plate, and run the lap and shoulder
portions of the vehicle’s safety belt through or
around the restraint. The child restraint instructions
will show you how.
2-33
To Next Page
Loading...
