V-8
ENGINE
6-41
BOXED
FRAME
FRAME
w
VIEW
"D
f
CROSS-MEMBER
VIEW "C"
STARTING
MOTOR
SUPPORT
SUPPORT
BRACKET
VIEW "B"
VIEW
"A'
Fig.
6-73
Pontiac
Engine
Insulators
ENGINE
INSULA
TORS—REM
O VE AND
REPLACE
TEMPEST
(Fig. 6-75) and
FIREBIRD
(Fig. 6-76)
FRONT
INSULATORS
1. Raise
hood
and, using J
22603
engine
lifting
tool,
Fig. 6-74, take
weight
of
engine
off front
insulators.
NOTE:
Disconnect battery ground strap before
raising
engine. When engine is raised, the start-
ing
motor solenoid terminals may contact the
steering
gear which could energize the starting
motor if ground cable is not disconnected.
2. Loosen rear insulator by removing crossmem-
ber to insulator
bolts
and raise rear of
engine.
3. Remove
bolts
which fasten front insulators to
frame bracket.
4. Raise
engine
just clear of insulators.
5. Remove insulator to
engine
bolts
and remove
insulators.
6. Position new insulators against
engine
and in-
stall
attaching
bolts
and washers. Tighten to 70 lb.
ft. torque.
7. Lower
engine.
8. Install frame bracket to insulator
bolts
with
lockwashers and
tighten
to 30 lb. ft. torque.
/
22603-4
22603
Fig.
6-74
Engine
Lifting
Tool
Instal
led—Pontiac
and
Tempest
To Next Page
Loading...
