Pontiac tempest 1968 - Page 259

6-42
1968 PONTIAC SERVICE MANUAL
(8 CYL, ENGINES * BOTH SIDES)
Fig. 6-75 Tempest Engine Insulators
9. Lower rear of engine and transmission so that
rear insulator positions on crossmember. Install
two crossmember to Insulator bolts and washers and
tighten to 30 lb
0
ft. torque.
REAR INSULATOR
1. Remove two crossmember-to-insulator bolts.
2. With suitable lifting equipment, raise trans-
mission at rear to provide clearance for removing
Insulator to transmission housing bolts.
3. Remove two Insulator-to-transmission bolts and
remove Insulator.
Fig. 6-76 Firebird Engine Insulators